VIR MDF is a homogeneous wood fiber Material ideally suited to modern machine tooling.

VIR MDF can be worked easily with all conventional woodworking machines. It saws cleanly and drills easily. It also shapes and routs exceptionally well, without splintering or chipping. VIR MDF is equally suited for use with most hand tools.


Sanding after molding or routing produces a much smoother finish. The molded edges can be sanded with any number of different profile sanders. Various polyurethane based abrasive wheels are available to fit to spindle molders or in line with a double end tenoner. These wheels can be shaped to the cutter profile using an abrasive paper glued to the desired edge profile 180/240 grit is usually used for finish sanding with finer grades available.


The crafts man can also work on VIR MDF with standard hand tools, which makes it ideal for intricate design. For best results blades and cutters should be sharp at all the times.


The internal bond strength of VIR MDF gives substantially better screw holding over other types of panel product.

Type of screw

Most types of screw can be used. Best results are obtained with fully thread screws. A high overall diameter to core ratio is desirable.


Due to their 100% natural composition and to their untreated surfaces, Green Blade sheets evolve a little more than laminates, or traditional non-woven papers. Thus before their use, they must be perfectly conditioned. Best conditioning consists in storing supports and sheets for 8 to 10 days, in a room in which the atmosphere is as close as possible to that of the buildings where the sheets will be assembled or worked with. Conditions will need to be within the following ranges:

Temperature of 18° to 25° C.

Relative humidity: 50 – 60%.

The use of a Green Blade sheet too wet or too dry risks product deformations, cracking from shrinkage or blisters in the event of veneering. Generally, it is preferable to store sheets in a dry environment rather than an environment that is too humid.


Properties Requirements as pre Result of VIR MDF as certified by IPIRTI
As per 12406:2003 IS: 12406-2003
1.Dimension and Tolerance
a) Length ±3mm/m 2
b) Width ±3mm/m 1
c) Thickness ±0.3mm/m 0.08
d) Squareness, mm/m Max 2 1
e) Edge straightness, mm/m Max 2 1
2.Workmanship and Finish —— Conforms
a) Average, Kg/cbm 600-900 761
b) Variation form mean density, % ±10 ±0.46
4.Water Absorption, %
a) After 2hrs. Soaking Max 9 6.9
b) After 24hrs. Soaking Max 20 16.5
5.Linear Expansion (maximum)
a) Due to general Absorption after 24 hrs. Soaking
*Thickness Max 7 5.4
*Length Max 0.4 0.24
*Width Max 0.4 0.22
b) Due to surface Absorption (in thickness) after 24hrs. Max 5 3.87
6.Moisture Content
a) Average 05-Oct 6.18
b) Variation from mean moisture content ±3 ±0.2
7.Modulus of Rupture
a) Average Min 28 32.9
b) Minimum individual Min 25 31.9
8. Modulus of Elasticity, N/mm²
a) Average Min. 2800 3149
b) Minimum Individual Min. 2500 3082
9. Tensile Strength Perpendicular to surface (Internal Board Strength), N/mm²
a) Dry Test
i) Average Min 0.8 0.9
ii) Minimum individual Min 0.7 0.8
10.Screw without strength, N
a) Face Min 1500 2965
b) Edge (For thickness >12mm) Min 1250 1710
error: Content is protected !!